ELFCAM
Description
Pack of 2 Gigabit fibre / Ethernet media converters for a single single-mode fibre, built-in SC port: they extend an RJ45 network up to 20 km between two buildings. Each converter has 2 RJ45 ports at auto-negotiated 10/100/1000 Mbit/s.
Over a single single-mode fibre, SC connector.
A transmits at 1310 nm, B at 1550 nm: they answer each other on the same fibre.
10/100/1000 Mbit/s, auto-negotiation.
No settings: connect the fibre and the network cable.
Dissipates heat, low consumption, continuous duty.
Fibre, link, activity, duplex and power visible at a glance.
One fibre, 20 km
Both converters work over a single fibre, single-mode: A transmits at 1310 nm and receives at 1550 nm, B does the opposite. The link reaches up to 20 km.
SC on one side, RJ45 on the other
The SC fibre port is built in: no module to add. The 10/100/1000 Mbit/s RJ45 ports adapt by themselves to the speed of the connected device.
Linking two sites
On each side, two devices directly, or a switch serving computers, surveillance cameras and router. The two networks become one, at 1 Gbit/s.
Built to run non-stop
The metal casing removes heat, consumption stays low and the converters run 24/7, in a technical room as well as in a garage.
Pack of 2 Gigabit fibre / Ethernet media converters, single-fibre single-mode SC, 1310/1550 nm, up to 20 km, 2 + 2 RJ45 ports 10/100/1000 Mbit/s, metal casing.
Great quality. The build quality exceeds expectations for this price. Best fiber cable I’ve used.
Excellent produit. Le câble passe facilement dans les gaines existantes. Je recommande sans hésiter.
Nothing to complain about. No signal loss detected over the full length. Best value for money.
Superb. No microbending issues even in tight spaces. Would buy again without hesitation.